A proper home on the wall for your Veloretti or Lekker e-bike battery — designed and tested by our family, here in the Netherlands.
Mount it in 4 steps
Pick the spot
Near a socket, comfy height. Check for hidden wiring & pipes before you drill.
Drill
Ø6 mm bit, ~35 mm deep — a little past the plug so the screw has room to bite.
Set the plug
Push in the plug. It grips every common wall — see below.
Mount & hang
Level it, drive the screw into each hole, and make sure it's securely mounted.
One plug — every wall
Two fischer DuoPower plugs are included — they grip almost any wall: plasterboard, hollow or perforated brick, solid brick, concrete and stone.
Simple on your wall, stubborn on our workbench. Designed and tested through many prototypes in the Netherlands. Thanks for supporting a small family studio. — Fietsnest
Was it a good fit?
An honest review helps another rider find this mount — good or bad, it all helps a small maker improve.
Scan to review — or go to clk.fietsnest.com/etsy/VLKR-01