A proper home on the wall for your Bosch e-bike battery — designed and tested by our family, here in the Netherlands.
Mount it in 4 steps
Pick the spot
Near a socket, comfy height. Check for hidden wiring & pipes before you drill.
Drill
Ø6 mm bit, ~35 mm deep — a little past the plug so the screw has room to bite.
Set the plug
Push in the plug. It grips every common wall — see below.
Mount & hang
Level it, drive the screw into each hole, and make sure it's securely mounted.
One plug — every wall
Two fischer DuoPower plugs are included — they grip almost any wall: plasterboard, hollow or perforated brick, solid brick, concrete and stone.
5 Orient the connector
Insert the cable from below. Line the connector up with the engraving inside the mount so it seats the right way. Make sure to push it all the way in.
6 Snap the cable in
Press the cable into the built-in clip until it clicks — it just holds the cable securely in place.
Simple on your wall, stubborn on our workbench. Designed and tested through many prototypes in the Netherlands. Thanks for supporting a small family studio. — Fietsnest
Was it a good fit?
An honest review helps another rider find this mount — good or bad, it all helps a small maker improve.
Scan to review — or go to clk.fietsnest.com/bol/BSCH-02